Prototype
As it may start melting up to down, all the electronic components (except Node MCU due to its dimensions) are implemented inside of the cylinder on a mini bread board on the bottom of it, IR sensor is visible in the picture and also a heating ring is placed on the top of it. The cylinder is made in a mold (it is not a candle).
As it may start melting up to down, all the electronic components (except Node MCU due to its dimensions) are implemented inside of the cylinder on a mini bread board on the bottom of it, IR sensor is visible in the picture and also a heating ring is placed on the top of it. The cylinder is made in a mold (it is not a candle).
Heating element
Molding
Electronics
Heating element
This heating element is a ring of Nichrome wire covered with heat resistant varnish and coiled with copper wire. The nichrome wire is connected to two electricity wires and gets hot and conducts heat to copper coil.
It is placed inside of the cylinder material when it was being molded.
Bottom button
This is a simple button which is designed for jumping game and it sends a signal every time you pick the cylinder up or put it down on a surface.
Heating element
This heating element is a ring of Nichrome wire covered with heat resistant varnish and coiled with copper wire. The nichrome wire is connected to two electricity wires and gets hot and conducts heat to copper coil.
It is placed inside of the cylinder material when it was being molded.
Bottom button
This is a simple button which is designed for jumping game and it sends a signal every time you pick the cylinder up or put it down on a surface.
